Please wait.'

Page is loading'


Home  > Raw materials & technologies  > Technologies  > UV/EB Coatings  > Controlling the adhesion strength of photo...

Tuesday, 17 September 2019
pdf
Raw materials & technologies, Technologies, UV/EB Coatings

Controlling the adhesion strength of photo-responsive adhesives

Thursday, 19 October 2017

Researchers from Florida State University have developed a facile method to control the adhesion strength of photo-responsive bio-inspired adhesives via a photocleavable crosslinker.

Controlling the adhesion strength of photo-responsive adhesives. Source: Pixabay

Controlling the adhesion strength of photo-responsive adhesives. Source: Pixabay

They synthesised a photo-responsive bio-inspired adhesive consisting of a zwitterionic polymer, poly(sulfobetaine methacrylate) (pSBMA), DOPA (3,4-dihydroxyphenylalanine), and a photocleavable nitrobenzyloxycarbonyl containing crosslinker by thermally-initiated free radical polymerisation.

Three components

The main component, pSBMA, is a highly hydrophilic zwitterionic polymer with a high potential for biomedical application. The DOPA functionality, an extensively studied major component of the adhesion properties in mussels, is known to universally enhance polymeric adhesion properties even in the presence of water. The third component, a nitrobenzyl-containing dimethacrylate crosslinker, is efficiently cleaved upon UV irradiation.

Rapid photocleavage

Proton NMR analysis of the crosslinker, 2-nitro-1,3-benzenedimethanol dimethacrylate (NBDM), demonstrates that photocleavage of the o-nitrobenzyl ester occurs rapidly for 30 minutes, then gradually continues for another 3 hours. The same patterns of photocleavage were observed in a terpolymer adhesive containing the nitrobenzyl crosslinker, poly(N-methacryloyl-3,4-dihydroxyl-L-phenylalanine-co-sulfobetaine methacrylate-co-2-nitro-1,3-benzenedimethanol dimethacrylate), poly(MDOPA-co-SBMA-co-NBDM).

Reduction in adhesion properties

The terpolymer adhesive demonstrated a reduction in adhesion properties over the course of irradiation corresponding to the cleavage rate observed by 1H NMR analysis of NBDM. After 30 minutes of UV irradiation the original adhesion strength, 341 kPa, was decreased to 223 kPa, corresponding to a 35% reduction. The adhesion strength continued to decrease to 150 kPa at the 3 hours mark, a 56% reduction compared to the original adhesion strength.

The study is published in: Polymer Chemistry, Issue 40, 2017.

top of page
Comments (0)
Add Comment

Post comment

You are not logged in

register