Please wait.'

Page is loading'


Home  > Raw materials & technologies  > Technologies  > Powder coatings  > Nanoparticles enhance mechanical propertie...

Wednesday, 15 July 2020
pdf
Raw materials & technologies, Technologies, Powder coatings

Nanoparticles enhance mechanical properties of powder coatings

Tuesday, 26 November 2013

In a study, the effect of various micro and nano-sized particles on the mechanical and adhesion properties of a commercial non-pigmented polyester-TGIC powder coating was investigated.

Researchers from Iran have improved mechanical properties of powder coating samples

Source: siehe FL 2

Researchers from Iran have improved mechanical properties of powder coating samples

Source: siehe FL 2

The researchers from the Iran Polymer & Petrochemical Institute and the Eastern Michigan University, Coating Research Institute (CRI),  prepared different coating formulations containing various wt.% of aluminum hydroxide (alumina) particles, TiO2and two different types of fumed silica nanoparticles via a two-stage process. Tensile strength measurements, DMTA analyses and vertical pull off adhesion test were conducted to evaluate mechanical and adhesion properties of the powder coating samples.

The extent of enhancing properties depends on the wt.%

The results revealed that the mechanical properties of the powder coating samples were improved with respect to the particles loading up to 2wt.%. The extent of this effect depends on the weight fraction and size of the particles. The fumed silica nanoparticles with dimethyl dichlorosilane treatment revealed to be more effective to enhanced mechanical and adhesion properties due to relatively better dispersion and plausible chemical interactions between silane treatment on the nanoparticles surface and polymeric matrix. The fluctuation in the mechanical properties was also observed as the particles content further increased up to 3wt.% due to an undesirable dispersion of the particles and in turn to the presence of aggregates, air pockets as well as discontinuity in the film.

Pre-dispersion of nanoparticles is a useful method

Eventually, the results revealed that pre-dispersion of nanoparticles in an appropriate solvent such as ethanol with the aid of ultrasonic irradiation, is a useful and applicable method before addition to a powder coating formulation. In fact, applying ultrasonic irradiation facilitates breaking down of nanoparticles aggregations to possible primary particles.

The study is published in: Progress in Organic Coatings, Volume 76, Issue 11, November 2013, pp 1625-1632.

top of page
Comments (0)
Add Comment

Post comment

You are not logged in

register