Please wait.'

Page is loading'


Home  > Raw materials & technologies  > Raw materials  > Waterborne polyurethane based on AAS-Na an...

Tuesday, 17 September 2019
pdf
Raw materials & technologies, Raw materials

Waterborne polyurethane based on AAS-Na and LDMPA

Thursday, 26 April 2018

In a recently published paper, aliphatic diamine sulphonate (AAS-Na) and liquefiable dimethylol propionic acid (LDMPA) were used together to synthesise waterborne polyurethane (WPU) with excellent property.

A new paper deals with the synthesis and characterisation of waterborne polyurethane (WPU). kasto – stock.adobe.com.

A new paper deals with the synthesis and characterisation of waterborne polyurethane (WPU). kasto – stock.adobe.com.

The influence of -COOH/-SO3Na molar ratio on the structure and properties of the waterborne polyurethanes were characterised by IR, particle size analysis, DSC, DMA, apparent viscosity, water absorption, contact angle, tensile and peel strength tests. It was found that with decreasing -COOH/-SO3Na molar ratio from 10:0 to 3:7, the particle size of the waterborne polyurethane emulsion decreased, while the apparent viscosity of the samples increased.

Increasing the storage modulus of the sample

The water absorption of the WPU films decreased, while the contact angle of the films increased. The tensile strength, elongation at break and peel strength of the samples increased. Furthermore, the results of DMA showed that incorporation of AAS-Na increased the storage modulus of the sample. And the results of DSC showed that with decreasing -COOH/-SO3Na molar ratio from 10:0 to 3:7, Tg of soft segment shifted to lower temperature, which indicated that the micro-phase separation degree of the samples increased.

The study is published in: Progress in Organic Coatings Volume 118, May 2018, Pages 116-121.

top of page
Comments (0)
Add Comment

Post comment

You are not logged in

register