Please wait.'

Page is loading'


Home  > Raw materials & technologies  > Applications  > Development of a highly corrosion-resistan...

Sunday, 16 December 2018
pdf
Raw materials & technologies, Applications

Development of a highly corrosion-resistant copolymer for metal surfaces

Tuesday, 9 October 2018

Recently, scientists investigated the corrosion behavior of AISI 316 stainless steel coated with modified fluoropolymer in marine condition.

According to measurements, the corrosion protection of 316 stainless steel was drastically increased by the use of the KP mixture (a combination of PVDF + PMMA). Source: Paco Verdera – Fotolia.com.
According to measurements, the corrosion protection of 316 stainless steel was drastically increased by the use of the KP mixture (a combination of...

In the maritime industry, stainless steel corrosion resistance requires further surface improvement and further enhanced protection using surface coatings. In a new study, an engineered copolymer of polyvinylidene fluoride (PVDF) with polymethylmethacrylate (PMMA)-blended coating was found to provide outstanding corrosion resistance for metal surfaces affording protection against severely corrosive marine environments. Electrochemical measurements indicate that corrosion protection of 316 stainless steel was drastically increased when utilising the KP blend (a combination of PVDF + PMMA), producing a new set of corrosion properties and morphological characteristics.

Significant decrease in corrosion rate

The corrosion protection of the KP coating proved to be very effective in reducing the passive region current density from 2.19 × 10−5 A/cm2 (for bare stainless steel) to 2.63 × 10−10 A/cm2 and the breakdown passive region potential at 0.25 V. This was followed by a significant decrease in corrosion rate, when compared to pure PMMA and PVDF films, during exposure to artificial marine seawater. With the KP film, impedance measurements surpassed those of other films, with a noticeable nonpeak straight line in the phase angle diagram. Optical observation showed that corrosion pits and delamination areas existed under the coatings.

The study is published in: Journal of Coatings Technology and Research  September 2018, Volume 15, Issue 5, pp 945–955.

top of page
Comments (0)
Add Comment

Post comment

You are not logged in

register